Hello All,
Need some help adjusting my chart page. I would like to have my side scan 3/4 of the page and down scan 1/4 of the page. Does anyone know how to adjust this on the gen 3's? Also I am new to running these graphs, is their a good turorial out there?
Gen 3
Moderator: Ken Sauret
-
- Posts: 776
- Joined: Sun Oct 18, 2009 7:39 pm
- Location: Paso Robles California
- Contact:
Re: Gen 3
Edd is right, just tap to select "Adjust Splits".
When you do this a circle with two opposing arrows will show up in the middle of the screen, just drag the circle/arrow to the desired panel sizes. Remember to hit "Save" as you exit so the changes will remain permanent until you choose to change them again.
When you do this a circle with two opposing arrows will show up in the middle of the screen, just drag the circle/arrow to the desired panel sizes. Remember to hit "Save" as you exit so the changes will remain permanent until you choose to change them again.
Ken Sauret
Lowrance Pro Staff
Lowrance http://www.lowrance.com/
Yamamoto https://store.baits.com/home
Dobyns Rods http://www.dobynsrods.com/
Yamaha http://www.yamaha-motor.com/
Personal Web Site http://kensbassfishing.weebly.com/
Lowrance Pro Staff
Lowrance http://www.lowrance.com/
Yamamoto https://store.baits.com/home
Dobyns Rods http://www.dobynsrods.com/
Yamaha http://www.yamaha-motor.com/
Personal Web Site http://kensbassfishing.weebly.com/
Copyright © 2013-2024 WesternBass.com ®