Page 1 of 1

Speedmaster

Posted: Sat Nov 13, 2010 10:00 am
by offduty
I have a 201 speedmaster that is a few years old. I was using it for punchin and had the drag locked down tight. Now the drag slips so bad it is unuseable. What happened and can I fix it by replacing washers for the drag? I can replace them myself but where can I order them?

Rich

Re: Speedmaster

Posted: Sat Nov 13, 2010 7:38 pm
by DanIsaac
Unfortunately, sounds like it's time for a new reel. Parts are almost impossible to find for those reels now.
Bantam1 may have another option but I doubt it.

Dan

Re: Speedmaster

Posted: Mon Nov 15, 2010 6:47 am
by bantam1
There might be some aftermarket drag washers available.

I think its time to move on and buy something new. This reel has probably more than paid for itself over the years. These were made in the late 80's. That is over 20 years of service. The new reels outperform this reel in every way. I think you will be much happier with a new model.

Re: Speedmaster

Posted: Mon Nov 22, 2010 12:41 pm
by fish_food
offduty wrote:I have a 201 speedmaster that is a few years old.
The Speedmaster that was sold a few years ago during the mid-2000s? Doesn't that model share identical gear sets with the Curado DHSV--if so, drags should be plentiful. It's the JDM deep spool version CU-200DHSV isn't it?

Re: Speedmaster

Posted: Mon Nov 22, 2010 2:41 pm
by bantam1
He did not specify he had the JDM model reel. This is why I think it might be the older model Speedmaster reel we used to offer in the US.

Re: Speedmaster

Posted: Sat Dec 11, 2010 9:23 pm
by offduty
SPDMSTR.jpg
SPDMSTR.jpg (32.38 KiB) Viewed 1269 times
Here is a pic of a similar reel.

Rich

Re: Speedmaster

Posted: Mon Dec 13, 2010 6:00 am
by bantam1
That should be the same reel as the Curado 200DHSV. You can order the drag washer for the Curado and install it. 877-577-0600

Re: Speedmaster

Posted: Mon Dec 13, 2010 10:26 pm
by offduty
bantam1 wrote:That should be the same reel as the Curado 200DHSV. You can order the drag washer for the Curado and install it. 877-577-0600
Can I upgrade to a better drag washer the one I had in did not last long?

Rich

Re: Speedmaster

Posted: Tue Dec 14, 2010 6:06 am
by bantam1
There is nothing we offer. The stock washer should last a while with proper maintenance. There could have been a lack of grease on the washer from the factory which led to the premature failure.