Page 1 of 1
Lose signal on plane
Posted: Sat Feb 14, 2015 6:02 pm
by Humminbird
I had a hummingbird 898 installed , and they put the transducer on the first flat spot of the transom. I would lose the signal when I would get on plane, so I moved the transducer to the lowest part of the transom, next to the drain plug, and it still loses the signal when I get on plane. I replaced my 12 year old lowrance unit with this one, and my old unit kept the signal up to about 50 mph. Am I doing something wrong or did I just spend $1500 for a state of the art sonar unit that only works when you are idling?
Re: Lose signal on plane
Posted: Mon Feb 16, 2015 8:42 pm
by Doug Vahrenberg
Post picture of your install. To get onplane reading the transducer MUST be a little below the lowest point of the hull or you can mount higher and get 2D onplane readings from a second transducer. Share some pictures and we can help
Re: Lose signal on plane
Posted: Tue Feb 17, 2015 8:17 am
by mark poulson
I had the same issue with my 997. I moved the transducer down so it's next to the drain plug, and so the bottom half of the transducer is below the hull, and it now reads at speed, up to 40mph.
Re: Lose signal on plane
Posted: Wed Mar 30, 2016 11:14 am
by edsterone
I have the same problem. But I was told the best way to mount the transducer was on my jackplate with a "Transducer Shield and Saver" and if you look at the photo you can see that the transducer sits about 7 to 8 inches higher than the lowest part of the boat. I thought that it would be far enough away from the bottom of the hull but apparently not. Any input?