Page 1 of 1

Installing External Transducer on MinnKota Ulterra

Posted: Fri Jul 03, 2015 3:13 pm
by Doug Vahrenberg
Installing Transducer on MinnKota Ulterra.

I seen a dealer design this set-up to allow for a external transducer to be installed on Ulterra and not wrap or interfere with Stow or Deploy Functions

Image

Image

Image

Re: Installing External Transducer on MinnKota Ulterra

Posted: Tue Nov 24, 2015 11:18 am
by redrooster
I plan on trying this setup on my recently purchased ulterra. Now off to find the right spring. Also i was wondering if that is a special bracket to hold the ducer to the trolling motor?

Re: Installing External Transducer on MinnKota Ulterra

Posted: Tue Nov 24, 2015 10:14 pm
by Hookset5
I own a Terrova, currently using the US2 but will be installing an external TM ducer next week. What about the channel method? Have you seen that done? Where you run the cable up the shaft slot and glue it in place with silicone.

Re: Installing External Transducer on MinnKota Ulterra

Posted: Tue Dec 15, 2015 8:53 pm
by McLovin
Can anyone tell me if this set up is working