I recently purchased two brand new 7 inch Carbon units and an Elite TI2 9 inch unit. Is it possible to use one transducer (3n1) and connect it to the Carbon and Elite TI2 units? Y cable or something? What I want to do at my console is display left side scan on one unit and right side scan on the other unit. If not, can I do this with the two Carbon units.
Thanks
Steve
Connecting two Lowrance units
Moderator: Ken Sauret
-
- Posts: 57
- Joined: Wed Nov 18, 2015 6:29 am
Re: Connecting two Lowrance units
No between Carbon and Ti and with 2 Carbon you need a Ethernet cable between the 2 Carbon
Re: Connecting two Lowrance units
Would this be the same situation if i wanted to connect my current HDS Live 7 to a second unit? Looking at either a Carbon or Ti2.wallyandre wrote:No between Carbon and Ti and with 2 Carbon you need a Ethernet cable between the 2 Carbon
Thanks in advance.
-
- Posts: 57
- Joined: Wed Nov 18, 2015 6:29 am
Re: Connecting two Lowrance units
HDS to HDS by Ethernet: full capability
HDS to Ti (NMEA2000) limited capability
HDS to Ti (NMEA2000) limited capability
-
- Posts: 776
- Joined: Sun Oct 18, 2009 7:39 pm
- Location: Paso Robles California
- Contact:
Re: Connecting two Lowrance units
I would also look at the performance of the units and what you are expecting out of them. For the cost of an additional transducer you will have better results and the units will live up to your expectations.
Ken Sauret
Lowrance Pro Staff
Lowrance http://www.lowrance.com/
Yamamoto https://store.baits.com/home
Dobyns Rods http://www.dobynsrods.com/
Yamaha http://www.yamaha-motor.com/
Personal Web Site http://kensbassfishing.weebly.com/
Lowrance Pro Staff
Lowrance http://www.lowrance.com/
Yamamoto https://store.baits.com/home
Dobyns Rods http://www.dobynsrods.com/
Yamaha http://www.yamaha-motor.com/
Personal Web Site http://kensbassfishing.weebly.com/
Copyright © 2013-2024 WesternBass.com ®