Just purchased a boat with an HDS Gen 2 non touch in the console and an HDS Gen 2 non touch on the bow. I installed an HDS 9 Gen 2 touch on the console and linked all three with eithernet cables.
I am trying to use the HDS 5 on the console for my charting but when I make a waypoint on the 9 inch with structure scan it does not transfer over to the chart on the console.
Anyone know if there is something I can do?
Lowrance Eithernet Question
Moderator: Ken Sauret
-
- Posts: 57
- Joined: Wed Nov 18, 2015 6:29 am
Re: Lowrance Eithernet Question
Be sure that you are running the latest software version on every units.
-
- Posts: 776
- Joined: Sun Oct 18, 2009 7:39 pm
- Location: Paso Robles California
- Contact:
Re: Lowrance Eithernet Question
You will need to check the Send Waypoint and Receive Waypoint in Settings. To do this hit the pages key and go to Network. In Network go down to NMEA 2000 and hit enter. Make sure the Send and Receive Waypoints are turned on in all 3 units.
Ken Sauret
Lowrance Pro Staff
Lowrance http://www.lowrance.com/
Yamamoto https://store.baits.com/home
Dobyns Rods http://www.dobynsrods.com/
Yamaha http://www.yamaha-motor.com/
Personal Web Site http://kensbassfishing.weebly.com/
Lowrance Pro Staff
Lowrance http://www.lowrance.com/
Yamamoto https://store.baits.com/home
Dobyns Rods http://www.dobynsrods.com/
Yamaha http://www.yamaha-motor.com/
Personal Web Site http://kensbassfishing.weebly.com/
Copyright © 2013-2024 WesternBass.com ®