Page 1 of 1

need a Mercury 200hp midsection

Posted: Fri May 16, 2014 3:20 pm
by marineproshops
need a 1995 and up midsection for a 20" shaft. must have 2 wire trim and ex bypass if its a 150 or 175 that will work also I will just change the tunner.
559-288-9990 keith

Re: need a Mercury 200hp midsection

Posted: Sat May 17, 2014 7:13 am
by GRAVES
I should have most or all of what you need from a 1996 200 hp. Powerhead & gear case are gone, the rest is in pieces. I also have a 2001 150 opti with low compression on #4.
916-799-5077 Bob

Re: need a Mercury 200hp midsection

Posted: Thu May 29, 2014 11:03 pm
by marineproshops
GRAVES wrote:I should have most or all of what you need from a 1996 200 hp. Powerhead & gear case are gone, the rest is in pieces. I also have a 2001 150 opti with low compression on #4.
916-799-5077 Bob
thanks for the good deal bob Sammy in la said hi. its a small world lol