Transducer Type question
Posted: Mon Jul 24, 2017 10:21 am
I recently had two networked HDS Gen 3 9's installed along w/ new transducers - both units are running the current 4.5 software.
My question is: I have a LSS-2 and, in the bilge area, a 2D shoot through puck (PDRT-WBL_transducer) and I want to make sure that for my Console HDS the correct Transducer is selected (see pic below). And here's the dumb question: should my Gen3 be looking at the LSS-2 skimmer and/or the 2D Sonar puck ? Does the LSS-2 have the option to be 'picked' or it just recognized by the graphs software etc ? I hope that question makes sense.
A reputable Nor. Cal shop did the install and I believe also did a good job then setting up & updating the units - but this is a big upgrade for me and I just want to make it is indeed set up properly.
Thanks in advance for any comments and responses!
My question is: I have a LSS-2 and, in the bilge area, a 2D shoot through puck (PDRT-WBL_transducer) and I want to make sure that for my Console HDS the correct Transducer is selected (see pic below). And here's the dumb question: should my Gen3 be looking at the LSS-2 skimmer and/or the 2D Sonar puck ? Does the LSS-2 have the option to be 'picked' or it just recognized by the graphs software etc ? I hope that question makes sense.
A reputable Nor. Cal shop did the install and I believe also did a good job then setting up & updating the units - but this is a big upgrade for me and I just want to make it is indeed set up properly.
Thanks in advance for any comments and responses!