Bass Fishing Forum - Westernbass.com

I have two 12 Carbons and have recently updated software to both.
I have a Navionics Chip at the console, and "share" this with the one on the Bow.

Here's where I can't figure out what is going on.
The detail at the console is so much better than that on the bow.
Even the menu's look different.

What am I doing wrong???

I've attached a couple photos showing the difference.

Based upon what you have described, I would guess your software update (18.3) did not work in your console unit. In each HDS, go to System Settings and look at the About screen to verify which software version you have in each unit.

Make sure that you have FishNChip or what we call SonarChart turned on both units. Click map, map options, Fish N Chip or SonarChart.

I have verified that both Softwares are exactly the same.
I was going to take pictures and post those as well.

I have not heard of FishNChip or SonarChart before so I will look at that.

By the way the very detailed pic is HDS 12 at Console, Less detail in on the Bow.

Thanks guys,
Hopefully try tonight and let you know.

Rene

Are both units networked using N2K and Ethernet?

yes

If finds the Navionics Maps from Console, as I don't have a chip on the BOW except blank used for Software Updates.
That's what is strange. Both using same maps, but one is definitely not a defined, and I actually have two different screens.

What it looks like to me is the contour setting on the top pic is set to 1 foot and the bottom is set to 10 feet.

Edd

Rickyshabazz, you had it correct.
I found sonarchart and and now both screens are the same.

Thanks everyone for the support.

Rene