HDS-7

[calworks]

Any one have problems with the HDS units 5 -10 resetting themselves if they receive shock from a hard wave or bouncing? I have a HDS-7 on my tracker 17.5 and it re-set itself when i bounced a wave. Hopefully that won't happen again when I get the RAM mount installed. Right now its hard mounted with the gimbal bracket to the gunwale

[split172]

I have had that happen before with other units. Check all the wire connections. I had one that was loose under the console. It was a poor installation job by the place I had it done at in my opinion!

[calworks]

Tought of that so I checked the wiring and its all sound. Hope this isn't a g-force problem with the HDS units

[sro114]

I don't think it's a "G-Force" issue. We just got the crud beat out of us in big water and neither one of my units reset and this was at 40-60 mph. I had this on a humminbird unit that I had and when they installed it the jumper they ran to power was loose. It took me forever to find it. Good Luck

[NoCAL]

Check the fuse. You really have to push it down into it's holder. If it's not seated well, it will work fine until a big shock moves the constacts. You really have to jam it down in there.

NoCAL

[blkdog812]

you have a wiring or battery volt issue. check all grounds too. make sure they are clean and tight

[calworks]

FUSE, maybe that's it, I didn't think to check the fuse. I'll give it a try and see if it occurs again.

Thanks all for the assist