Broken bolt on my slidemaster jackplate

Post Reply
WildDog3
Posts: 229
Joined: Sun Jan 08, 2006 1:08 pm
Location: San Mateo

Broken bolt on my slidemaster jackplate

Post by WildDog3 »

The main bolt that raises and lowers my motor on my slidemaster jackplate just broke about two inches down from the top and now my motor is as low as it can go on the jackplate and I can't raise it. Has anyone ever had this happen? I hope they don't have to replace the whole jackplate and can just replace that big bolt.
jloo283
Posts: 137
Joined: Fri Jul 29, 2011 10:15 am

Re: Broken bolt on my slidemaster jackplate

Post by jloo283 »

Ouch, were you running without the entire plate tighten down with other bolts? That worm screw by itself isn't meant to hold everything, especially while underway. Anyways, I'm sure you can find comparable worm screw if you know the pitch and length. I'd get a stainless steel one if I could. Good luck.

James
WildDog3
Posts: 229
Joined: Sun Jan 08, 2006 1:08 pm
Location: San Mateo

Re: Broken bolt on my slidemaster jackplate

Post by WildDog3 »

I had everything tightened down properly. I really don't think that bolt should have sheared off like that.
blkdog812
Posts: 874
Joined: Wed May 11, 2005 4:27 pm
Location: "If people concentrated on the really important things in life, there'd be

Re: Broken bolt on my slidemaster jackplate

Post by blkdog812 »

contact slidemaster....................see what they recommend or if they might send a replacement part
Never argue with an idiot; He'll beat you to death with stupidity.
I AM NOT SAYING THERE SHOULD BE CAPITAL PUNISHMENT FOR STUPIDITY,
BUT, WHY DON'T WE JUST TAKE THE SAFETY LABELS OFF OF EVERYTHING
AND LET THE PROBLEM SOLVE ITSELF?"
Post Reply