Who sells Motorguide shear pins?

Ralph_198 · Post by **Ralph_198** » Fri Jan 19, 2007 9:28 pm

I have a TR109 Motorguide w/Machette prop. Where can I buy the shear pins? Anglers? or maybe online?

Thanks!

Schneider Fishing · Post by **Schneider Fishing** » Fri Jan 19, 2007 9:30 pm

Angler's
Last Chance I think has some. Call first.
Angler's will mail them out to you.
If you're fish the DVL event on Saturday I usually have an extra on my boat.

DeltaDan · Post by **DeltaDan** » Fri Jan 19, 2007 10:25 pm

Ralph- I was just wondering if you have diven to your local Ace harware first?

You can take your prop in there and drop it right in to make sure they fit into the plastc hub- then run it through your shaft later for a confirmed fit.

They will go for about 40 to 70 cents each compared to 2-3+ dollars from other places for the same piece of rolled metal.

--Just a lesson/observation on my part.

mark poulson · Post by **mark poulson** » Sat Jan 20, 2007 4:22 am

Try The Trolling Motor Dr. They're a site sponsor, and are on the banner at the top of the forum page.

Ralph_198 · Post by **Ralph_198** » Sat Jan 20, 2007 7:59 am

Thanks to all!

JohNNy Utah · Post by **JohNNy Utah** » Sun Jan 21, 2007 11:53 am

Just a thought...............
My Motorguide has extra shear pins in the base of the gatormount.(in front)
I never would have known they were there if Brian D. hadn't shown them to me. Take a look.