Wanted:Sweet Beaver molds!!

bassbusta01 · Post by **bassbusta01** » Wed Jun 29, 2005 10:12 pm

I need some sweet beaver molds the 3.5" and the 4.20"any help would be great.

my e-mail address is csfebaits@rtinet.com

TomAtkeson · Post by **TomAtkeson** » Wed Jun 29, 2005 10:59 pm

Andre Moore Im sure he will be happy to send ya some.......hahaha.

RipnRog · Post by **RipnRog** » Thu Jun 30, 2005 6:05 am

Has a patent on it. So I dought you will find any molds. If you do then watch what you do. Why dont you just contact Reaction Innovations and see about purchasing them in bulk.

TWinger · Post by **TWinger** » Thu Jun 30, 2005 12:24 pm

Here is a site that has lots of molds, it should show the beavers,

http://www.lurecraft.com/catalog.htm

TWinger · Post by **TWinger** » Thu Jun 30, 2005 12:30 pm

They are located on page 15, all three sizes of molds

http://www.lurecraft.com/catalog.htm

Tm Customs · Post by **Tm Customs** » Thu Jun 30, 2005 2:40 pm

The ones lure craft has are crap these are the ones to have! 50 bucks for 2 cavities is kinda pricy though

PS sweet beavers are not protected by a patent

tmyers · Post by **tmyers** » Fri Jul 01, 2005 11:00 am

try del-mart.com or bobstackleshack.com i beleive at one time they both made aluminum molds.

a lot of info been discussed on this over at tackleunderground.com in the soft plastics forum.

My .02 on the patent/rights issue (even though no one asked), if you are going to pour your own in your own custom colors etc. for your own use have at it, as for duplicating for resale, the guy succesfully "created" and marketed a bait, let him have his notoriety and $$.

good fishing,

Chad S · Post by **Chad S** » Fri Jul 01, 2005 3:20 pm

Thanks you Tim Myers for stating what needed to be said. Always someone looking to make a buck on someone elses ideas. Get your own idea and run with it.