Motor Guide parts

KDA · Post by **KDA** » Wed Jun 02, 2010 6:57 am

I need to find a replacement activator switch for a 2005 47# motor guide trolling motor. The switch is located on the underside of the foot control. When I push down on the top of the foot control there is too little contact with the activator switch, thus sometimes the motor does not turn on. I inspected the switch, a small rubber cap that fits over a steel post (switch) has worn out. I have tried adding tape to create the needed pressure but that is a short lived fix.

thanks for the help

Rod Wynn · Post by **Rod Wynn** » Wed Jun 02, 2010 7:04 am

Call the Trolling Motor Doctor..
I would put a link up of his website but I think it's been hacked..

THE TROLLING MOTOR DOCTOR 3720 Industry Avenue Suite 105. Lakewood CA 90712 800-944-9446. Mon--Fri 9 am to 5:00 pm. Closed Sat & Sun ...

McLovin · Post by **McLovin** » Wed Jun 02, 2010 10:14 am

Just know that if you order a part from the trolling motor doctor and that part is defective,he will not refund you your money. Not bashing just stateing the facts.

mark poulson · Post by **mark poulson** » Wed Jun 02, 2010 10:17 am

Try putting a small dab of silicone on top of the switch, and using a piece of a baggie to cover it, so it doesn't stick to anything else. Then push down on it with the pedal, checking to see how it spreads, until it's the thickness you need. It will last forever, if you let it cure for a few days after you do it.

Lugnut · Post by **Lugnut** » Wed Jun 02, 2010 1:37 pm

Try C&C Marine in Modesto. Last time I needed a replacement part for my Motorguide, they had it in stock.

DaveH · Post by **DaveH** » Wed Jun 02, 2010 1:43 pm

call Scott he's in the Valley,He's at Action Tackle alot, his number is, 818-9293845, thats a very common wear item on a MG, pick up two, or do yourself a favor and Get a Minnkota