Miller Punch Weights and a Bass N' Tuber

sTony · Post by **sTony** » Sat Sep 04, 2010 2:38 am

Ready for viewing is the latest episode of WesternBass.TV.

A trip on the water with Danny Miller and the Miller Punch Weight. Rob Linden takes a shot at the Delta and talks about Bass N Tubes. Randy Pringle talks Berkley product and a tip from Bub Tosh of Paycheck Baits.

Here's a direct link to the new show:

http://www.westernbass.tv/videopage.php?0000876

As always the show is viewable in any of three formats; Windows Media, Quicktime or Divx. Approximate run time is 30 minutes.

sTony

JDG · Post by **JDG** » Sat Sep 04, 2010 6:40 am

Good job Rob, the video looks great. Couldnt hear a word you said though, audio? Nice work. Cya in October.

J Graves

ugly stick · Post by **ugly stick** » Sat Sep 04, 2010 5:15 pm

not sure if it was my computer but the words kept skippin

ASD · Post by **ASD** » Sat Sep 04, 2010 5:48 pm

It's working ok for me.

But i wish Cooch an Danny would not tell the hole world about MPW's as they work great and now every one will have them

Flippinjigs · Post by **Flippinjigs** » Sat Sep 04, 2010 8:54 pm

I use the Miller punching weights. They work very well. Just Be careful. As mentioned in the video you don't want them weights coming back to you at a high rate of speed after pulling a snag free. They have a very sharp point at each end. In fact you don't want to let one slip from your fingers either and hit your boats gel coat while pitching. They are likely to take a chunk of gel coat off your boat if the point hits first. I have boat wounds that I have repaired. Other wise great weight.

"In Coming"

&
Good Fishing

Bass Fishing Forum - Westernbass.com