Do I have a bad transducer?

[Whoopbass]

I have a Humminbird Onix graph at the helm. I was fishing and just happened to walk back in time to watch the bottom of the lake work its way off the screen. The graph won't display a picture, depth, or temp reading. Down imaging doesn't work either. Everything else on the graph works fine. The wire and puck have no damage. I've never had this happen before but I suspect the transducer. Thoughts??

I went outside and turned it on. I do hear the transducer ticking. I restored it to factory default and the temp is working now so maybe its working. Can't tell in the driveway.

[JVGondal]

Check the cable where it connects to the graph if you have not. Vibration might have it loose

[Fast Eddie]

Depending on what day you were fishing, it may have overheated. Switch to simulator and view screen in driveway. If it's working , it's not the screen which is probably good news.
Good Luck
TL
FE

[BOOTH GUY]

My Solix did the same thing last week. Factory reset fixed it. Take a extra transducer and plug it to the back and drop it overboard to test.