Idiosyncrasies of Ghost Trolling Motor

Moderators: MKA, Caudawg

Post Reply
Fast Eddie
Posts: 165
Joined: Tue Aug 02, 2005 2:48 pm

Idiosyncrasies of Ghost Trolling Motor

Post by Fast Eddie »

Just wondering if it's common that you have to pedal down (heel) and tap the power button to get your Ghost to release so it can be stowed?
TL
FE
johnb
Posts: 26
Joined: Thu Apr 15, 2010 1:24 pm
Location: san jose

Re: Idiosyncrasies of Ghost Trolling Motor

Post by johnb »

no you can go into the settings and everytime you bring it up it will go to left or right
Fishermans Warehouse Megastore
Posts: 147
Joined: Sun Apr 14, 2019 5:57 pm

Re: Idiosyncrasies of Ghost Trolling Motor

Post by Fishermans Warehouse Megastore »

On my Ghost I have to just snap the pull cord and it releases. If you just pull slowly, it won’t release. Just try a quick jerk and it will release every time. The head will always turn and lay flat.
Alan Fong
Fisherman's Warehouse Sacramento
(916) 362-1200
User avatar
Marc
Posts: 1021
Joined: Sat May 07, 2005 9:08 pm
Location: Steilacoom, WA
Contact:

Re: Idiosyncrasies of Ghost Trolling Motor

Post by Marc »

Your Ghost should deploy and retract very smoothly. The key is in proper mounting. It should be mounted with 6 bolts and on a perfectly flat and level surface. Some boats do not have a level surface, and in that case when you tighten all bolts the mount bends to conform to the fiberglass surface. That is called putting your mount in a bind. This will cause the locking pin to not smoothly release when you pull the cable.

You can tell if this is your problem by loosening your bolts a little bit (especially the front two) and then checking the operation of your motor during deployment and retraction. If it is smoother then you know your mount needs to be adjusted.

Lowrance provides rubber washers for this situation with all Ghost motors. Use these to level an unlevel surface. Usually the front bolts are where the washers usually are needed.

I highly recommend getting your Ghost mounted correctly. Makes it a pleasure to deploy and retract, and keeps it from getting damaged by components that are binding and have to be forced.
www.RangerBoats.com
www.Evinrude.com
www.QuickDropsWeights.com
www.Yamamoto.Baits.com
www.Lamiglas.com
www.Gamakatsu.com
www.LuckyCraft.com
www.Lowrance.com
www.TransducerShieldandSaver.com
Pepsi man
Posts: 50
Joined: Wed Mar 03, 2021 4:53 pm

Re: Idiosyncrasies of Ghost Trolling Motor

Post by Pepsi man »

What Alan said..sometimes it feels like I'm about to rip that dang cord off trying to get it to pop. I do find it easier when I lean forward and pull straight up rather than at an angle towards me..once its popped the head turns and the gas struts take over for a smooth landing.
Post Reply